If your brake light is not working My Auto Shop can get it sorted with a Brake Inspection. Simply leave as many details about the issue as you can and we will contact local MTA approved mechanics that are qualified to fix the underlying issue. We'll email you quotes for an inspection within 2 working days, and where possible provide an indication as to the likely underlying issue(s) and cost to fix. You can book directly on the My Auto Shop platform in minutes.

How a Brake Inspection works with My Auto Shop:

A qualified mechanic will check over your entire braking system to understand whats causing the issue. This includes checking of the brake fluid for contamination, brake lines, and removing the wheels to measure the thickness of the brake pads, rotors or shoes (if applicable).

The following components are looked at during a Brake Inspection:

- Brake pads and shoes

- Hydraulic fluid

- Rotor and drum wear

- Calipers

- Wheel cylinders

- All brake hardware

- All hoses and lines

- Master cylinder

- Anti-lock system

They will then quote up any repairs or replacement parts if required.

When your brake light is not working its often as a result of a:

• Blown fuse
• Bad brake light switch
• Burnt out bulb
• Dirty contact in bulb socket

Popular services linked to a Brake Inspection:

Brake Booster Replacement

Your brake booster is what makes it easier to press the pedal in and slow the car down. You’d be surprised how hard it is to physically brake your car without a booster. It makes driving a whole lot easier and it’s something that you won’t truly appreciate till it’s gone.

Brake Master Cylinder Replacement

Your brake master cylinder is what makes your car stop when you press the brake pedal. When you press the brake pedal, this puts pressure through the master cylinder which then distributes this pressure to the brakes on the 4 different corners of the car. It’s completely essential to your brakes working as they should so it should be in perfect working condition at all times.

Brake Shoe Replacement

Most modern cars use disc brakes on all four corners. However, older cars and even some modern ones, use drum brakes. Inside drum brakes are shoes. These shoes press against the spinning drum and slow you down via friction. They were most commonly used on the rear wheels as they don’t require as much braking force.

ABS/Wheel Speed Sensor Replacement

These sensors have a pretty important job to do. These sensors tell your car how fast the wheels are rotating, this is then checked against the vehicle speed. If one wheel is spinning faster than the others then the ABS module will apply the brakes to that wheel to slow it down. If the wheel is registered as spinning slower or not spinning at all, then the ABS module will take steps to stabilise the wheel.